Best Hydraulic Car Jacks Review 2021

Hydraulic car jack – Buying Guide, Opinions and Analysis

 

Hydraulic jacks have the ability to lift very heavy objects at different heights. For this reason, they are a suitable tool when changing parts and checking the underside of cars. If you are interested in acquiring one of these products, it is convenient that you take into consideration different characteristics, among them its design, size, resistance, stability, maximum load capacity, maximum and minimum elevation level, among others. To facilitate the task of choosing between all the available models, we will mention some of the most outstanding ones. The first is the Einhell BT-HJ 2000 , a bottle type jack that has the capacity to support a weight of up to two tons, in addition, it lifts cars to a maximum height of 35.4 cm. On the other hand, theMichelin 92416 has swivel wheels that will help you move it more easily and its maximum lift range is 35 cm.

How to use a hydraulic car jack

 

When you have a car it is important to have all the necessary parts to deal with any eventuality. Such is the case of the hydraulic jack. This equipment must be handled with care to avoid unfortunate accidents and injuries. Next, we will provide you with a set of tips so that you can use it without problems.

 

 

 

Park your vehicle in a safe place

When you are going to use a hydraulic jack, the first thing to consider is the terrain. This point is very important because adequate stability is needed to be able to keep the vehicle lifted without problems. Try to park it on a flat, firm and safe ground, which facilitates the process.

 

Secure the car

Once parked, you need to make sure it stays in place. A good way to do this is by straightening the steering wheel, putting the vehicle in park or neutral (in the case of manual gear cars), and setting the parking brake as hard as you can. These steps will prevent the car from moving.

 

Find the right support points

Each vehicle integrates a series of special places where the hydraulic jack can be easily adapted, which prevents certain damage to its bodywork.

You must be very aware, since not all places under a car can support the weight of it. This information can easily be found in your vehicle’s owner’s manual or by doing a quick search on the Internet. Having this information at hand is essential when you need to do some work with the hydraulic jack.

 

Put the cat in the right place

In some cases, when you don’t want to risk damaging the vehicle body, you can place some large pieces of wood, such as short logs, between the jack and the car itself. Remember to put all the parts in the correct way so that they cannot get in the way or cause accidents.

 

 

 

Raise the jack little by little

This process must be done carefully and with great precision or else it could cause an accident. First move the mechanisms, the main lever, according to the instructions in the manual for the hydraulic jack (some move clockwise and others counter clockwise), take your time and do it slowly.

Raise the vehicle to the desired height so that you can work properly, always keeping your attention on any changes that may occur during the lift.

Once you have the desired height, check the stability of the car and use additional supports if necessary to properly support the vehicle. Remember that your safety is the most important thing when doing any mechanical work.

 

Lower the car carefully

After carrying out the work on your car, it is essential that you lower it very carefully and calmly, in the same way in which you lifted it. To do this, remember to first remove the additional supports that you have placed on it. Lower the entire mechanism little by little until your car is on its four wheels again.

 

 

Leave a Comment

Your email address will not be published. Required fields are marked *